Small Feed Roll Shaft, Rollers & Paper Flap Removal; System Board Removal - Lexmark WinWriter 150c Service Manual

4077-001
Small Feed Roll Shaft, Rollers & Paper Flap Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the carrier frame assembly.
4. Spread the left and right side frames apart far enough to remove
the small feed roll shaft assembly.

System Board Removal

1. Remove the front cover.
2. Unlock the four printhead cable connectors and disconnect the
printhead cables from the system board.
3. Disconnect the other cables from the system board.
4. Gently release the tension on the encoder strip by flexing the
encoder strip tensioner and remove the encoder strip from the
left side only.
5. Remove the three screws securing the system board to the
carrier frame and remove the system board. Note the routing of
the paper feed motor cable.
Note: The head to head and bidirectional printing alignments will be
reset to factory defaults. The user, through the WinWriter 150c
Printer Control program, is directed to perform these alignments.
When reinstalling the system board, it is easier to insert the
printhead cables in the four connectors prior to installing the board.
Repair Information
46