Dell PowerEdge T430 Owner's Manual page 91

CAUTION: To prevent damage to the memory module or the memory-module socket during
installation, do not bend or flex the memory module; insert both ends of the memory module
simultaneously.
2. Align the edge connector of the memory module with the alignment key of the memory module
socket, and insert the memory module in the socket.
NOTE: The alignment key allows you to install the memory module in the socket in only one
way.
CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both
ends of the memory module evenly.
3. Press the memory module with your thumbs until the socket levers firmly click into place.
Figure 36. Installing the memory module
1. memory module
3. memory-module socket ejector (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in
3. Press <F2> to enter System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the installed memory.
4. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure
that the memory modules are firmly seated in the sockets.
5. Run system memory test in system diagnostics. See
Related Links
Removing the cooling shroud
Installing the cooling shroud
Removing memory modules
After working inside your
Dell Embedded System
2. alignment key
system.
Diagnostics.
91