Dell PowerEdge T430 Owner's Manual page 150

4. Lay the system on a flat and stable surface.
5. If installed, remove the system feet or caster wheels.
6. Remove the system cover.
Steps
1. Remove the control panel assembly from the chassis.
2. Remove the control panel assembly cover.
3. Install the VGA module.
4. Install the control panel assembly cover for rack mode into the control panel assembly.
5. Remove the system top cover.
6. Install the control panel assembly for rack mode into the chassis.
7. To attach the rack ears, follow the steps below:
a. Align the three screw holes on the right rack ear with the screw holes on the right side of the rack
system.
b. Install the three screws using a #2 Phillips screwdriver.
Figure 68. Removing and installing the rack ears
1. front panel
3. screws for each rack ear (3)
Next steps
1. Install the system cover.
150
2. rack ears (2)