Dell PowerEdge T430 Owner's Manual page 21

Item Indicator, button, or
connector
2, 6, 8 USB connectors (6)
3 System identification
button
4 iDRAC port (optional)
5 System identification
connector
7 vFlash media card slot
(optional)
9, 12 Ethernet connectors (2)
10 Video connector
11 Serial connector
13 PCIe expansion card slots
(6)
Icon Description
Non-redundant
power supply
Allows you to connect USB devices to the system.
Five ports are USB 2.0-compliant and one port is
USB 3.0-compliant.
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flash until one
of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter the BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
Dedicated management port on the iDRAC ports
card.
Allows you to connect the optional system status
indicator assembly through the optional cable
management arm.
Allows you to insert a vFlash media card.
Two integrated 10/100/1000 Mbps NIC
connectors.
Allows you to connect a VGA display to the
system.
Allows you to connect a serial device to the
system.
Allows you to connect up to six full-height PCI
expansion cards.
One 450 W non-redundant
AC power supply.
NOTE: Non-redundant
power supply is
supported in systems
with cabled hard drives
and systems with an x8
backplane.
21