Installing The Power Interposer Board - Dell PowerEdge T430 Owner's Manual

Figure 54. Removing and installing the power interposer board
1. GPU power connector
3. release latch
5. slots (4)
Related Links
Removing a redundant AC power supply
Removing the cooling shroud

Installing the power interposer board

Installing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Ensure that you read the
Steps
1. Align the slots on the power interposer board (PIB) with the hooks on the power supply cage and
slide the PIB until it snaps into place.
2. Route the power cables through the securing clips as applicable, and connect the power cables to
the system board.
3. Route the P3 power cable through the securing clip on the system board and connect power cable
to the hard-drive backplane.
Safety instructions.
2. power interposer board
4. hooks (4)
127