Fitting The Thermostat - DELTA DORE TYBOX 610 Installation Manual

Fitting the thermostat

We recommend that you install your device:
- where there is easy access, such as a corridor, living room or entrance hall,
- on an interior wall at a height of 1.50m from the floor
approx.
1.50 m
Your appliance will also show you
the room temperature.
It is therefore recommended that
it be installed well removed from
any sources of heat (e.g. convec-
tors, chimney) and draughts (e.g.
doors, windows).
- 4 -
• Remove the protective tab from the batteries.
• Open the thermostat housing by pressing on clip
• Unscrew the locking screw on the protective cover of the
connecting terminal box.
2
• Mount the base using suitable screws and screw anchors or
fit into a flush-mounted box.
1
- 5 -
➊
➌
Partitions (mark ) that can
be removed with pliers
enable connecting wires to
be used, if required.
3 3