MTU 20 V 4000 M93 x Operating Instructions Manual page 16

Fitting the transport locking de-
vice on driving end (KS)
Note: Attach plate (6) only to the upper part of the openings.
1. Secure the plates (6) with screws (4) and washers (5) at the bores on both sides of the flywheel housing
and tighten to the specified tightening torque.
Name
Screw
2. Screw locknut (2) onto screw (1) up to the end of the thread.
3. The long end of the holder (3) must face downwards. Insert holder (3) through the openings in the
plate (6).
Note: The holder (3) must lock the flywheel only, not the ring gear.
4. Turn screw (1) in bores of holder (3) until holder (3) is secured.
Note: The screw (1) must be tightened alternately on both sides of the flywheel housing.
5. Tighten screw (1) to specified tightening torque.
Name
Screw
6. Place locknut (2) of screw (1) in position on plate (6) and lock it.
Removing the transport locking
device from driving end (KS)
1. Release the locknuts (2) on both sides of
the flywheel housing, remove screw (1) and
take off holder (3).
2. Unscrew screws (4) and remove together
with washers (5) and plates (6).
3. Store the removed parts of the transport
locking device together with this documen-
tation carefully for possible reuse.
16 | Safety | MS150048/04E 2013-07
Size Type
M16 Tightening torque
Size Type
M10 Tightening torque
Lubricant Value/Standard
(Engine oil) 250 Nm +25 Nm
Lubricant Value/Standard
(Engine oil) 30 Nm +3 Nm