IMPORTANT:
1. The silica gel loses its effectiveness when the dry camera is
opened. To prevent the lens from fogging up, replace the silica gel
bag every time when you open the camera and conceal the gel bag
in the camera within two minutes of exposing to the open air.
2. For each newly replaced silica gel bag, allow it to absorb moisture
for at least 5 hours before operating the camera.
6.4.4 Installing the Sun-Shield Cover
After setting up the Bullet Camera, now you can install the sun-shield cover
to the camera.
1.
Fasten the hexagon screws either on top or below the camera.
2.
Put the sun-shield cover on top of hexagon screws. Make sure to aim
the rear hexagon screw at the edge of the sun-shield cover's aperture
for optimal sun-shield performance.
82
Figure 6-19
Figure 6-20