Additional Required Adhesives; Before Starting Assembly - Hangar 9 SU-26MM Sukhoi Assembly Manual

Additional Required Tools
Cut-off wheel Sanding drum
Drill Epoxy brush
Felt-tipped pen Ruler
Hex wrench: 1.5mm, 2.5mm, 3mm, 4mm, 4.5mm, 3/32-
inch, 5/32-inch Iron
Hobby knife with #11 blade Mixing cup
Mixing stick Paper towel
Pencil Hemostat
Shoo Goo or Zap-A-Dap-A-Goo
Phillips screwdriver: #1, #2 Pin vise
Vise grip Masking tape
Rotary tool Rubbing alcohol
Nut driver: 1/4-inch Heat gun
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
3/32-inch (2.5mm), 3/16-inch (5mm)
6

Additional Required Adhesives

Medium CA (PAAPT02)
Thin CA (PAAPT08)
CA remover/debonder (PAAPT16)
CA accelerator (PAAPT15)
Threadlock (PAAPT42)
30-Minute Epoxy, 8 oz (PAAPT39)

before Starting Assembly

Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect the
fuselage, wing panels, rudder and stabilizer for damage. If
you find any damaged or missing parts, contact the place of
purchase.
If you find any wrinkles in the covering, use a heat gun or
covering iron to remove them. Use caution while working
around areas where the colors overlap to prevent separating
the colors.
HAN100 – Heat Gun
HAN150 – Covering Glove
HAN101 – Sealing Iron
HAN141 – Sealing Iron Sock
Hangar 9 3.1m Sukhoi SU-26MM ARF Assembly Manual