Pipes/Canisters Mount Installation And Assembly - Hangar 9 SU-26MM Sukhoi Assembly Manual

Pipes/Canisters Mount Installation and
Assembly
Required Parts
Pipe or canister mounts Silicone tubing
Required Parts (not included)
MTW RE3 Pipe MTW 110 Canister
50mm drop header, 14-inch for RE3 tuned pipe setup
50mm drop header, 8-9-inch for MTW 110 canister setup
Couplers Clamps
Required Tools and Adhesives
Hobby knife Felt-tipped pen
5-and 30-minute epoxy Clamps
Vise grip Iron
Rotary tool with cutter disk Ruler
Masking tape Industrial lubricant
Acid brush Mixing cup and sticks
Pipes Mount Installation

1. Kit comes with 4 pipe mounts, 2 canister mounts
and silicone tubing. Two support locations are selected for
pipe installation. Pipe mounts need to be doubled up for
increased glue surface area and strength. Scratch the surface
of each mount with a hobby knife.
18

2. Glue the layers using a thin layer of 5-minute epoxy.
Clamp until glue cures.

3. Pass the silicone tubing through the middle hole and
go through each hole in the circumference of the mount
from the inside until you are back at the same middle hole
that you started. Cut off the silicone tubing to prepare the
next pipe mount.

4. Prepare the fuselage for pipe installation. Remove the
covering as pictured and iron down the edges. Masking tape
can be used to give good guidance when cutting.
Note: Final picture is shown below to give a good
perspective as where to remove the covering.
The picture below is of the bay immediate aft of landing
gear.
Hangar 9 3.1m Sukhoi SU-26MM ARF Assembly Manual