Extron electronics FOXBOX Tx HDMI User Manual page 30

Command/response table for Receiver SIS commands (continued)
Command ASCII Command
(host to unit)
Memory presets
X1*
Save preset
X1*
Recall preset
Auto memory
Disable auto memory 55*0#
Enable auto memory 55*1#
55#
Show auto memory status
Audio mute
Mute the audio 1Z
0Z
Unmute the audio
Z
Show audio mute status
Test pattern
NOTE:
You must have a video input connected to the transmitter and the transmitter-Tx-to-receiver-Rx fiber cable connected for the
receiver to output a selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power
is removed.
Output color bars 1J
Output grayscale 2J
3J
Output alternating pixels
0J
Turn test pattern off
J
Show test pattern status
Disable and enable return link and daisy chain
NOTE:
The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connected to any of outputs 2 through 6 on the DA.
Disable return link 66*0*0#
Enable return link to 66*0*1#
transmitter
66*0*2#
Enable daisy chain
Show return link and daisy 66*0#
chain status
Video bit depth
E
Set video bit depth to auto
E
Force video to 8-bit depth
E
View video bit depth
HDCP notification
Enable notification EN1HDCP}
Disable notification EN0HDCP}
View notification status ENHDCP}
NOTE: X( = Mute and auto memory status
X1^ = Horizontal and vertical position
X1*
= Memory preset number
X1(
= Test pattern
X2) = Rx link and daisy chain enable
X2@
= Video bit depth
Response
(unit to host)
X1*]
, Spr
X1*]
. Rpr
]
Img0
]
Img1
X(]
]
Amt1
]
Amt0
X(]
]
Tst1
]
Tst2
]
Tst3
]
Tst0
X1(]
Rle*0*0
Rle*0*1
Rle*0*2
X2)]
0*
}
V0BITD BitdV0
}
V1BITD BitdV1
} X2@]
VBITD
HdcpN1]
HdcpN0]
X(]
0 = off
000 through 255
01 to 30
0 = none
1 = color bars
0 = disable
0 = auto
Additional description
Command code is a comma.
Command code is a period.
Silence the audio output of the receiver.
The receiver outputs audio.
Audio mute status is
Set the receiver to output the color bars test pattern.
Set the receiver to output the grayscale test pattern.
Set the receiver to output the alternating pixels test
pattern.
Set the receiver to output the input video (no test
pattern is selected).
]
Disable link 2.
]
Enable link 2 (default setting).
]
Enable receiver daisy chain mode.
]
]
1 = on
2 = grayscale
3 = alternating pixels
1 = return link enable
1 = 8-bit
FOXBOX Tx/Rx HDMI • Remote Control
X(
.
2 = daisy chain enable
24