Remote Control - Extron electronics FOXBOX Tx HDMI User Manual

Remote Control

This section describes the remote control operation of the FOXBOX HDMI and, including:
•
•
The transmitter and receiver each have a front panel Configuration port, a 2.5 mm
mini stereo jack (see
Operation" section. The receiver has a rear panel Remote RS-232 port, a 3-pole captive
screw connector (see
Any of these ports can be connected to a host device such as a computer running the
HyperTerminal or DataViewer utility, or a control system to make serial control of the
transmitter and receiver possible.
The protocol for all ports is as follows:
•
•
NOTE:
Simple Instruction Set Control
FOX Extenders Control Program
"Front panel Configuration
"RS-232 connections" in the "Installation and Operation" section.
9600 baud • no parity
1 stop bit • no flow control
RS-232 commands and FOX Extenders Control Program functions are
transmitter- or receiver-specific or may have different responses depending
on the unit connected. You must connect to the appropriate device for the
command or function to work properly or to get the expected response.
Ports" in the "Installation and
• 8 data bits
FOXBOX Tx/Rx HDMI • Remote Control 17