Power Supply; Weee Compliance - Datalogic DS6300 Reference Manual

The identification label is applied onto the bottom part of the scanner (Figure A, 2):
The laser diode used in this device is classified as a Class 3B laser product according to
EN60825-1 regulations and as a Class IIIb laser product according to CDRH regulations. As it
is not possible to apply a classification label on the laser diode used in this device, the
following label is reproduced here:
Any violation of the optic parts in particular can cause radiation up to the maximum level of
the laser diode (35 mW at 630~680 nm).

POWER SUPPLY

- This product is intended to be installed by Qualified Personnel only.
- All DS6300 Models:
This device is intended to be supplied by a UL Listed Power Unit marked "Class 2" or LPS
power source which supplies power directly to the scanner via the 25/26-pin connector.

WEEE COMPLIANCE

DATALOGIC S.p.A. Via Candini, 2
40012 LIPPO DI CALDERARA DI RENO (BO) ITALY
MANUFACTURED VOLT Amp.
JANUARY 2002 15-30 DC 1.5-0.5
MODEL No.
N2468
SERIAL No.
This product conforms to the applicable requirements
of 21CFR 1040 at the date of manufacture.
Device Identification Label
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAXIMUM OUTPUT RADIATION
EMITTED WAVE LENGTH
TO EN60825-1 (2001)
Laser Diode Class Label
35 mW
630~680 nm
vii