Compliance; General; Power Supply; Emc Compliance - Datalogic Matrix 320 Product Reference Manual

COMPLIANCE

GENERAL

For installation, use and maintenance it is not necessary to open the reader.
Only connect Ethernet and dataport connections to a network which has routing only
within the plant or building and no routing outside the plant or building.

POWER SUPPLY

ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT
The unit is intended to be powered by an external power supply ES1, PS2 according to
IEC 62368-1:2014.

EMC COMPLIANCE

In order to meet the EMC requirements:
•
•
•

CE COMPLIANCE

CE marking states the compliance of the product with essential requirements listed in
the applicable European directive. Since the directives and applicable standards are
subject to continuous updates, and since Datalogic promptly adopts these updates,
therefore the EU declaration of conformity is a living document. The EU declaration of
conformity is available for competent authorities and customers through Datalogic
commercial reference contacts. Since April 20th, 2016 the main European directives
applicable to Datalogic products require inclusion of an adequate analysis and assess-
ment of the risk(s). This evaluation was carried out in relation to the applicable points of
the standards listed in the Declaration of Conformity. Datalogic products are mainly
designed for integration purposes into more complex systems. For this reason it is under
the responsibility of the system integrator to do a new risk assessment regarding the
final installation.
Warning:
radio interference in which case the user may be required to take adequate measures.
connect reader chassis to the plant earth ground by means of a flat copper braid
shorter than 100 mm;
for CBX connections, connect pin "Earth" to a good Earth Ground;
for direct connections, connect your cable shield to the locking ring nut of the con-
nector.
This is a Class A product. In a domestic environment this product may cause
PRODUCT REFERENCE GUIDE
ix