Bolt-Down Option - DataCard SD260 Installation And Administration Manual

Bolt-Down Option

The laminator includes bolt‐down openings that you can use to secure the system
to a mounting surface.
This procedure is optional.
You need the following supplies:
The bolt‐down kit (part no. 509169‐001) contains two M6 well nuts.
•
Two M6 (6 mm) screws, purchased separately.
•
The length of the screws you need depends on the thickness of the mounting
surface. The screw length is the surface thickness + 0.75 inch (20 mm).
Two M6 washers, purchased separately.
•
1/4‐inch (7 mm) drill bit.
•
1.
Drill two holes in the mounting surface following the dimensions and
requirements shown in the following figure:
A-4 SD460 Laminating System