DataCard SD260 Installation And Administration Manual page 105

2.
Carefully tip the laminator
onto its left side (the side
without the access door).
3.
Insert the M6 well nut
threaded inserts into the
bolt‐down openings on the
bottom of the laminator.
4.
Return the laminator to its
upright position and
position it over the holes
that are drilled in the
mounting surface.
5.
Secure the laminator to
the mounting surface.
A.
B.
C.
SD Series Installation and Administrator's Guide
Place a flat washer on
each of the screws
beneath the mounting
surface.
Insert the M6 screws
through the holes in
the mounting surface
and into the well nuts
in the bottom of the
laminator.
Tighten the screws
securely.
A-5