DataCard SD260 Installation And Administration Manual page 70

Hopper1ImpressDwellTime—Set the time, in milliseconds, the impresser
•
remains in contact with the card. The default is 2000 ms (2 seconds).
•
•
Hopper1ImpressPositionOffset1—Set the distance from the back edge of the
•
card to the center of the first impression on the card.
•
•
Hopper1ImpressPositionOffset2—Set the distance from the back edge of the
•
card to the center of the second impression on the card.
•
•
Hopper1ImpressPositionOffset3—Set the distance from the back edge of the
•
card to the center of the third impression on the card.
•
•
Hopper1ImpressTemperature—Set the temperature of the impresser punch
•
(in degrees Celsius).
•
•
Hopper1NumberOfImpresses—Enter the number of impressions to be
•
stamped on the card. The impresser can stamp up to three impressions in a
row on the left, center, or right part of the card.
ImpresserSpeed—Set the speed of the impresser motor. The value is in
•
increments of the motor.
•
•
62
Increase the value to allow the impresser to remain on the card longer.
Decrease the value to impress the card for a shorter time.
Increase the offset value to increase the distance of the impression from
the back edge of the card.
Decrease the offset value to decrease the distance of the impression from
the back edge of the card.
Increase the offset value to increase the distance of the impression from
the back edge of the card.
Decrease the offset value to decrease the distance of the impression from
the back edge of the card.
Increase the offset value to increase the distance of the impression from
the back edge of the card.
Decrease the offset value to decrease the distance of the impression from
the back edge of the card.
Increase the value to increase the temperature of the impresser punch.
Decrease the value to decrease the temperature of the impresser punch.
Increase the value to increase the speed of the impresser motor.
Decrease the value to decrease the speed of the impresser motor.
Printer Manager