DataCard SD260 Installation And Administration Manual page 90

The following laminator supplies are available. All are available for a full card,
smart card, or magnetic stripe card.
Patch:
Clear DuraGard, 0.5 mil, up to 350 images/roll
•
Clear DuraGard, 1.0 mil, up to 300 images/roll
•
Holographic DuraGard 0.6 mil, Random, up to 350 images/roll
•
Holographic DuraGard, Registered, 0.6 mil, up to 350 images/roll
•
Holographic DuraGard, 1.0 mil, Random, up to 300 images/roll
•
Holographic DuraGard Registered, 1.0 mil, up to 300 images/roll
•
Topcoat:
Clear, number of images depends on lamination settings
•
Holographic, Random, number of images depends on lamination settings
•
Registered Holographic, up to 600 images/roll
•
*Clear DuraShield, number of images depends on lamination settings
•
82
* DuraShield overlay has the following requirements:
• It must be used with a ribbon that includes a topcoat panel: KT,
YMCKT, YMCKT‐K, YMCKT‐KT, ymcKT, YMCKF‐KT.
Note: If you use a YMCKF‐KT ribbon, refer to the printer's Driver Guide
for information about setting up a card design that uses the UV (F)
panel.
• It must be applied over the topcoat.
• It is supported only with PVC composite cards.
Supplies and Parts