DataCard SD260 Installation And Administration Manual page 83

Clean the Printer
1.
Unlock the system, if necessary.
2.
Remove the supplies.
A.
B.
C.
3.
Place the unwrapped cleaning card in the card input hopper.
4.
Select Maintenance > Cleaning.
5.
Select Clean Printer.
6.
Click Run to start the cleaning process. Press the U
when the message "172: Insert cleaning card" displays on the LCD panel.
The printer picks the cleaning card, moves it through the printer several times,
and ejects it in the output hopper or reject card tray.
7.
Remove the used cleaning card. Wait a few minutes for the rollers to dry.
8.
Replace the supplies.
A.
B.
C.
Clean the Laminator
1.
Select Clean Laminator on the Maintenance > Cleaning page.
2.
Click Run.
The printer LCD panel displays the message "172: Insert cleaning card."
3.
Insert the laminator cleaning card into the card exit slot of the laminator and
press the U
The laminator pulls the cleaning card from the card exit slot into the laminator
and moves it back and forth through the L1 and L2 cartridge areas and the
card entry area several times. The used card is ejected into the laminator
output hopper.
SD Series Installation and Administrator's Guide
Open the printer's top cover and remove the ribbon cartridge.
Remove any blank card stock from the input hopper.
Lock the printer.
Place the cards in the input hopper.
Replace the cleaning sleeve with a new sleeve and remove the protective
cover.
Replace the ribbon cartridge and close the printer cover. Lock the printer,
if necessary.
button.
SER
button on the printer
SER
75