Removing The Smartcard Reader - Fujitsu FUTRO S550-2 Operating Manual

System expansions

Removing the SmartCard reader

SmartCardreader
► Open the casing (see "Opening the casing", Page 22).
If a PCI board is installed, you must remove the cross piece and PCI board:
5
5
2
4
6
3
1
► Undo the screws (1) and cables on the cross piece which are in the way.
► Remove the cross piece (2).
► Remove the PCI board, (see chapter "Removing the PCI board", Page 27).
► Disconnect the cable from the SmartCard reader (3) and from the mainboard (4).
► Undo the screws (5).
► Lift the SmartCard reader from the securing bolt (6).
► Reinstall the cross piece and the PCI board (see "Installing the PCI board", Page 25).
► Close the casing (see "Closing the casing", Page 23).
30 Fujitsu Technology Solutions