User's Guide – Ultima cutting plotter
2. INSTALLATION PROCEDURES
2.1. PREPARING THE CUTTING ENVIRONMENT
The location where you set up your equipment is very important. Please see to it that it meets following
conditions:
Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
Ambient Conditions:
Operating environment
- Temperature: 5 °C to 30 °C
- Humidity: 35 % - 75 % non-condensing.
Recommended environment
- Temperature: Room temperature 16 °C to 25 °C
- Humidity: 50 % to 65 %, non-condensing.
Variation rate
- Temperature: 2 °C per hour.
- Humidity: 5 % per hour.
Storage environment
- Temperature: 0 °C to 50 °C
Please protect your cutter from moisture, dust, draughts and direct sunlight. It is best to keep your machine
away from open windows and air-conditioners.
See to it that there is an adequate space around the cutter so that ventilation is not obstructed.
Avoid unnecessary vibrations and set up your cutter on a level surface.
When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at the rear, as shown in the
illustration below.
11
AP-75032, Rev 2.2, 20/04/07