Assembling The Propeller Shaft Housing - Yamaha F225A Service Manual

LOWR
2. Check the dog clutch, shift rod joint, and
shift slider for cracks or wear. Replace if
necessary.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
É
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special tool in a manner that will force the
stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
25.05–25.55 mm (0.986–1.006 in)
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
6-43
Lower unit
É
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Bearing inner race attachment 4:
90890-06640
Depth d:
4.75–5.25 mm (0.187–0.207 in)
3. Install the original shim(s) 5 and thrust
bearing 6 with the propeller shaft into
the propeller shaft housing.
CAUTION:
Add or remove shim(s), if necessary,
when replacing the propeller shaft, thrust
bearing or propeller shaft housing.
4. Install the new taper roller bearing 7 and
bearing outer race 8 into the propeller
shaft housing using a press.
S69J6425
69J3D11