Installing The Power Trim And Tilt Motor - Yamaha F225A Service Manual

BRKT
Recommended power trim and tilt
fluid:
ATF Dexron II
3. Install the trim piston assembly into the
trim cylinder, and then tighten the trim
cylinder end screw 2 to the specified
torque.
WARNING
Do not push the trim rams down while
installing them into the trim cylinders.
Otherwise, the power trim and tilt fluid
may spurt out from the unit.
Cylinder-end screw wrench:
90890-06544
Trim cylinder end screw 2:
160 N·m (16 kgf·m, 115 ft·lb)
Installing the power trim and tilt
motor
1. Install the joint 1 into the pump housing.
7-39
Bracket unit
2. Fill the pump housing with the recom-
mended fluid to the correct level a as
shown.
Recommended power trim and tilt
fluid:
ATF Dexron II
3. Remove all of the air bubbles with a
syringe or suitable tool.
NOTE:
Turn the joint with a screwdriver, and then
remove any air between the pump gear teeth.
4. Install the new O-ring 2, power trim and
tilt motor 3, and then tighten the bolts 4
to the specified torque.
69J3D11