Installing The Tilt Cylinder; Installing The Trim Rams - Yamaha F225A Service Manual

Trim piston bolt:
38 N·m (3.8 kgf·m, 27 ft·lb)
4. Install the new O-ring 3, backup ring 4,
spring 5, adapter 6, and circlip 7 to the
trim piston 1.
5. Install the new oil seal 8, circlip 9, and
new O-ring 0 into the trim cylinder end
screw A.
6. Install the trim cylinder end screw A into
the trim ram 2.

Installing the tilt cylinder

1. Install the new O-ring 1 to the free pis-
ton 2.
2. Push the free piston 2 into the tilt cylin-
der 3 until it bottoms out.
69J3D11
Power trim and tilt unit
3. Install the tilt cylinder 3 to the cylinder
block 4.
4. Install pipes 5 and 6, and then tighten
them to the specified torque.
Pipe joint 5 and 6:
15 N·m (1.5 kgf·m, 11 ft·lb)

Installing the trim rams

1. Hold the cylinder block 1 in a vise using
aluminum plates a on both sides.
2. Fill the trim cylinders with the recom-
mended fluid to the correct level b as
shown.
1
2
3
4
5
6
7
8
9
7-38