Installing The Reservoir; Installing The Tilt Ram - Yamaha F225A Service Manual

NOTE:
Align the armature shaft with the recess in
the joint.
PTT motor bolt 4:
18 N·m (1.8 kgf·m, 13 ft·lb)

Installing the reservoir

1. Install the spacer 1, filter 2 and sheet
3 to the cylinder block.
2. Install the new O-ring 4 and reservoir
5, and then tighten the bolts 6 to the
specified torque.
3. Install the reservoir cap 7, and then
tighten it to the specified torque.
69J3D11
Power trim and tilt unit
Reservoir bolt 6:
18 N·m (1.8 kgf·m, 13 ft·lb)
Reservoir cap 7:
7 N·m (0.7 kgf·m, 5.1 ft·lb)

Installing the tilt ram

1. Fill the tilt cylinder with the recommended
fluid to the correct level a as shown.
2. Add a small amount of the recommended
fluid through the cylinder block hole b as
shown.
Recommended power trim and tilt
fluid:
ATF Dexron II
3. Install the tilt piston assembly into the tilt
cylinder, and then tighten the tilt cylinder
end screw 1 to the specified torque.
1
2
3
4
5
6
7
8
9
7-40