Assembling The Tilt Ram - Yamaha F225A Service Manual

3. Install the balls 7, manual release spring
8, and bracket 9 by installing the bolts
0, then tightening them to the specified
torque.
Gear pump bracket bolt 0:
7 N·m (0.7 kgf·m, 5.1 ft·lb)
4. Install the relief valve seal A and ball B
into the gear housing 1 5.
69J3D11
Power trim and tilt unit
5. Install the filters C and gear pump D by
installing the bolts E, then tightening
them to the specified torque.
6. Install the manual valve F.
Gear pump bolt E:
7 N·m (0.7 kgf·m, 5.1 ft·lb)

Assembling the tilt ram

1. Install the new dust seal 1, O-rings 2
and 3, and backup ring 4 into the tilt
cylinder end screw 5.
1
2
3
4
5
6
7
8
9
7-36