Assembling The Drive Shaft Housing - Yamaha F225A Service Manual

LOWR
CAUTION:
Add or remove shim(s), if necessary,
when replacing the forward gear or lower
case.
Ball bearing attachment 3:
90890-06657
Driver rod LL 4: 90890-06605
3. Install the needle bearing outer case into
the lower case.
É
NOTE:
Apply engine oil to the needle bearing outer
case before installation.
Bearing outer race attachment 5:
90890-06628
Bearing outer race puller 6:
90890-06523
4. Install the needle bearing into the needle
bearing outer case.
NOTE:
Apply engine oil or grease to the needle
bearing, and then install it.
6-49
Lower unit
5. Install the new needle bearings into the
reverse gear to the specified depth.
É
Needle bearing attachment 7:
90890-06653
Driver rod SS 8: 90890-06604
Bearing depth plate 9: 90890-06603
Depth b:
20.75–21.25 mm (0.817–0.836 in)
Depth c:
4.25–4.75 mm (0.167–0.187 in)
6. Install the thrust bearing and reverse
gear into the lower case.

Assembling the drive shaft housing

1. Install the needle bearing into the drive
shaft housing to the specified depth.
Needle bearing attachment 1:
90890-06610
Driver rod LS 2: 90890-06606
Depth a:
4.25–4.75 mm (0.167–0.187 in)
69J3D11