Operating Instructions - WaterLogic WL2000IT Technical Manual

Operating Instructions

DISPENSING yOUR CHOICE OF WATER IS VERy SIMPLE,
AS FOLLOWS:
1. Place your cup centrally in the dispensing area
2. Select the type of water you wish to be dispensed and press the corresponding
button.
3. Keep the button depressed until your cup has reached the desired level, and then
release the button.
COLD OPTION HOT OPTION
The option buttons are very simple to identify. The following table indicates the hot
and cold option, or cold and ambient option on the machine.
Button 1: select hot water
Main Button: to dispense
water from selection
COLD OPTION AMBIENT OPTION
Button 2: select ambient
water
14
COLD WATER
Push Main button, LED shows green, it dispenses cold water.
AMBIENT WATER
Push Ambient button LED shows red, Push main button
it dispenses ambient water.
HOT WATER
Push hot water button LED shows red, Push Main button,
it dispenses hot water
Note: Default mode is cold water. If you have a cold only machine you will
only have available the main button.
HOT WATER CAUTION
• Always place cup / mug in the centre of the drip tray.
• Always use a ceramic cup or a cup suitable for use with
hot water.
• Do not hold cup or place hands in dispensing area
whilst dispensing water.
• Do not dispense water in a stop start style of vending
• (Hold the button continuously until cup is full).
• Never try to fill more than one vessel at a time.
Waterlogic 2000IT Technical Manual - Issue B, December 2013
15