Panasonic AG-HPD24P Operating Instructions Manual page 62

TC/UB/CTL
Use this menu to set the time code.
Item
Selects 12 or 24 hour clock for the CTL counter display.
±12h: 12-hour clock display
CTL DISPLAY
24h: 24-hour clock display
Specifies whether or not a VITC signal will be output at the
locations selected in the VITC POS-1 and VITC POS-2 menus.
BLANK: VITC signals are not output.
THROUGH: VITC signals are output.
VITC BLANK
NOTE:
• This setting is enabled only during VIDEO and SD SDI output.
• In EE mode, the input signal is output with the VITC signal.
Specifies the position where the VITC signal will be inserted.
When set to 59.94 Hz: LINE 10 - LINE 16 - LINE 20
When set to 50 Hz: LINE 7 - LINE 11 - LINE 22
NOTE:
• You cannot select the same line as in the VITC POS-2 menu.
VITC POS-1
• This setting is enabled only during VIDEO and SD SDI output.
• Pressing RESET will not restore the factory defaults.
• VITC signals are not output when 23.98 Hz, 24 Hz, 59 - 23 or
60 - 24 is set in the SETUP - SYSTEM - FREQUENCY menu
setting.
Specifies the position where the VITC signal will be inserted.
When set to 59.94 Hz: LINE 10 - LINE 18 - LINE 20
When set to 50 Hz: LINE 7 - LINE 12 - LINE 22
NOTE:
• You cannot select the same line as in the VITC POS-1 menu.
VITC POS-2
• This setting is enabled only during VIDEO and SD SDI output.
• Pressing RESET will not restore the factory defaults.
• VITC signals are not output when 23.98 Hz, 24 Hz, 59 - 23 or
60 - 24 is set in the SETUP - SYSTEM - FREQUENCY menu
setting.
Sets the TC operating mode of the built-in time code generator.
REGEN: Synchronizes the internal time code generator to
maintain the continuity with the time code last recorded on the
P2 card.
TCG MODE PRESET: Starts recording from the value set with the TC
PRESET button.
EXIT: Uses the external time code input from the TIME CODE
IN connector, video signal VITC or SLTC. Use menu (EXT TC
SEL) to set.
Sets the UB operating mode of the built-in time code generator.
REGEN: Synchronizes the internal time code generator with the
last user bits recorded on a P2 card.
UBG MODE PRESET: Starts recording from the value set with the TC
PRESET button.
EXT: Uses the external UB from the TIME CODE IN connector,
video signal VITC or SLTC. Use menu (EXT TC SEL) to set.
62
Setup Menu: Menu items
Settings and brief function description
XX indicates factory default settings.
SYSTEM FREQ
indications
(Main)
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
59.94 Hz 50 Hz
59.94 Hz 50 Hz
59.94 Hz 50 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23Hz 60-24 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
Mode
2D
3D SYNC PB
M M M
M M M
M M M
M M M
M M
M M