Panasonic AG-HPD24P Operating Instructions Manual page 60

Item
Select reference for video output.
AUTO: Uses the reference signal input to the REF connector as
reference. When there is not input to the REF connector, the
selected video input signal is used as reference. When there
is no reference and video input signal, the internal clock is
used.
REF: The reference input signal is used as reference. If there is
no such signal, the internal clock is used.
INPUT: The video input signal is used as reference. If there is
OUTPUT REF
no such signal, the internal clock is used.
NOTE:
• In 2D/3D mode and at frequencies other than 59.94 Hz and
50 Hz, operation is fixed at AUTO.
• In 3D REC/PB mode, slave side settings are used. The master
side is fixed at REF.
• In SYNC PB mode, the REF setting is used.
• When the input video signal is INT SG, the internal reference
signal is used as a reference for input video signals.
Determines whether or not to engage repeat play during
playback.
ON: Engages repeat play. Continues playback from the
beginning when reaching the end of the last clip.
OFF: Does not engage repeat play. Stops playback at the end
of the last clip.
NOTE:
REPEAT PLAY
• Repeat play is not available during TEXT MEMO playback.
• If the P2 card is removed during repeat play, playback is
suspended when playback reaches the clip that is no longer
exists.
• Even if you insert a P2 card during repeat play, additional
clips are not played back until you once stop repeat play and
resume it.
Sets the maximum shuttle speed operation.
X8: 8× normal speed
X16: 16× normal speed
SHUTTLE MAX
X32: 32× normal speed
X60: 60× normal speed
X100: 100× normal speed
Sets the maximum speed of FF and REW operation.
X32: 32× normal speed
X60: 60× normal speed
X100: 100× normal speed
SEEK: Seek operation to start of clip
NOTE:
FF. REW MAX
• When SEEK is selected, FF and REW operations for FF and
REW commands transferred via 9P are performed at 100x
normal speed. Note that seek operations are initiated by the
FF and REW commands via 9P when ORIGINAL is set in the
ID OF 9P REMOTE menu. The cursor moves from left to right
in thumbnail screens.
• Seek (movement) is enabled in playback mode.
Specifies the location where a NEXT (SHIFT + FF) and PREV
(SHIFT + REW) seek operation moves to.
SEEK POS SEL
CLIP: The start of the clip
CLIP&TEXT MEMO: The start of the clip or video text memo
60
Setup Menu: Menu items
Settings and brief function description
XX indicates factory default settings.
SYSTEM FREQ
indications
(Main)
59.94 Hz 50 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
59.94 Hz 50 Hz
23.98 Hz 24 Hz
59-23 Hz 60-24 Hz
Mode
2D
3D SYNC PB
M M
M M M
M M M
M M M
M