Panasonic AG-HPD24P Operating Instructions Manual page 23

Setup to attach meta data
■ Preparing for meta data recording
Use this procedure to determine whether or not to attach the
loaded meta data to clip that is recorded.
(➝ Setup Menu "META DATA" page 54)
■ Select method for recording the USER CLIP
NAME
Use this procedure to set the type of data recorded as USER
CLIP NAME.
(➝ Setup Menu "META DATA" page 54)
Choose the META DATA - USER CLIP NAME menu setting
and the META DATA - RECORD menu setting combinations to
record different data.
Recording method USER CLIP NAME to be recorded
Clip meta data TYPE1
RECORD=ON
TYPE2
Clip meta data TYPE1
RECORD=OFF
TYPE2
■ Counter value
The counter value is indicated as a four-digit number. When
recording method "TYPE 2" is selected for the USER CLIP
NAME in the clip meta data that is loaded, the counter value
is incremented by 1 for each new recording and a new clip is
generated.
Use the following procedure to reset the counter value.
1.
Press the MENU button.
2.
Use the Up/Down/Left/Right cursor buttons to
choose the META DATA - PROPERTY - USER CLIP
NAME menu setting from the meta data screen and
press the SET button.
3.
Use the Up/Down/Left/Right cursor buttons to
choose COUNT RESET and press the SET button.
The counter value is reset to 1.
4.
Press the EXIT button to end processing.
Read meta data settings
Read meta data settings
+ counter value
Same as GLOBAL CLIP
ID
Same as CLIP NAME
Incrementing the counter value of the USER CLIP
NAME for clips exceeding 4 GB
In the following case, one shot is recorded as multiple clips
and the counter value is automatically incremented and
recorded for each shot.
• When an 8 GB or larger P2 card is used in this unit and each
continuous recording exceeds a specified time.
(➝ "Dividing clips over 4 GB in length" Vol. 1, page 30).
• When one recording spans multiple cards.
Example of a recording on one P2 card (DVCPRO HD):
REC start
(start of recording)
Recording duration = 6 minutes
Clip 1
Counter value = A
Approx. 5 min.
Example of recording a clip on two P2 cards:
REC start
(start of recording)
Clip 1
Counter value = A
1st card
A P2 device will indicate the thumbnail and the counter value
of clip 1 when thumbnails and property of the clip are
displayed.
Meta data upload files
■ Loading files
Use the following procedure to load meta data from an SD
memory card.
1.
Insert the SD memory card storing the meta data
upload file.
2.
Open the thumbnail screen.
3.
Press the MENU button.
Stop
(recording stop)
Clip 2
Counter value = A + 1
Approx. 1 min.
Stop
(recording stop)
Clip 2
Counter value = A + 1
2nd card
4,5,6
3,7
Main Mode: Thumbnail Screen
23