Panasonic AG-HPD24P Operating Instructions Manual page 32

1
Connecting a Storage Device.
2
Open the thumbnail screen.
3
Press the MENU button.
4
Use the Up/Down/Left/Right cursor buttons to
choose the STORAGE - EXPLORE menu setting
and press the SET button.
The EXPLORE screen appears.
1)
2)
1)
Display status
Indicates that the name of the screen is the EXPLORE
screen for the storage device.
2)
Device information
The following information appears.
Storage PARTITION:
device that
VENDOR:
makes it
MODEL:
possible to
SIZE:
read and
USED:
write data by
card (TYPE
S, P2
STORE).
FREE CAP.:
SELECTED PART.: Number of selected
Storage PARTITION:
device other
VENDOR:
than above
MODEL:
(FAT,
SIZE:
OTHER)
FREE CAP.:
SELECTED PART.: Number of selected
3)
Partition information (for a TYPE S storage device or
P2 store disk)
:
32
Main Mode: Thumbnail Screen
3)
TYPE S / P2 STORE
Name of vendor
Model name
Total capacity (unit: GB)
Memory used (unit: GB)
Used P2 card area
(unit: cards) up to 23
cards
Remaining capacity
(Unit: GB)
partitions
FAT/OTHER
Name of vendor
Model name
Total capacity (unit: GB)
Remaining capacity
(Unit: GB)
folders
Check marks appear for selected
partition.
NUMBER(NO.):
MODEL:
PARTITION
NAME:
DATE / TIME:
SERIAL:
Folder information (for a FAT type storage device)
:
NUMBER(NO.):
FOLDER NAME:
DATE / TIME:
◆ NOTE:
4)
• Use the Left/Right cursor buttons to toggle between the
partition names and serial names for TYPE S formatted
storage devices.
• The partition information for an invalid partition on a P2
store is indicated in gray.
• Select the PROPERTY - FREE CAP. OF PARTITION menu
setting in the menu to check the remaining capacity of the
partition.
4)
Storage device indicator
Indicates whether or not a storage device is connected
and device type.
■ Operations in the EXPLORE screen
Selecting partition or folder as target
Selecting a partition or folder as target allows you to display
all the clips in the selected partition or folder as thumbnails.
(➝ "Thumbnail Screen Display" Vol. 1, page 34)
Use the following steps to select up to six partitions or folders
to use in this way.
1.
Select a partition or folder in the EXPLORE screen.
2.
Hold down the SET button (1 sec or longer) to
complete the operation.
A check mark
partition or folder.
Partition number (1 - )
P2 card model name
Name assigned to partition
(➝ "Entering a partition name" page 33)
Date and time of partition recording
P2 card serial number
Check marks appear for selected folder.
Folder number (1 - )
Folder name (does not include
CONTENTS folders)
Folder creation date
2
1
appears on next to the selected