Switching To The Usb Host Mode; Usable Hard Drives - Panasonic P2HD AG-HPG20 Operating Instructions Manual

Copying data from P cards to the hard drive (continued)

Switching to the USB HOST mode

1
Hold down [POWER] for at least 1 second to
turn the power on.
The thumbnail screen now appears.

Press [THUMBNAIL/MODE] to display the
normal display screen.

Press [MENU/MODE CHK].

Using , and
FUNCTIONS" – "PC MODE SELECT", and
press .
5
Using and
press .
6
Press [MENU/MODE CHK] twice to display
the normal display screen.

Usable hard drives

The following hard drive can be used.
• Panasonic portable hard disk unit for P2 store (AJ-PCS060G)
• Any hard drive which can be connected using USB 2.0
• USB bus power (5 V, 0.5 A) is also supported, but some hard drives cannot be started up using it. If this
is the case, supply power from a separate source to the hard drive.
• Some hard drives may not operate properly.
• Do not use USB memories or other removable media.
6
, select "OTHER
, select "USB HOST", and

Hold down [THUMBNAIL/MODE] for at least
 seconds.
The USB HOST mode is now established,
and "USB HOST" appears at the bottom of the
thumbnail screen.
• Use a hard drive with enough memory to
accommodate the data to be copied.
To exit the USB HOST mode
1
Hold down [THUMBNAIL/MODE] for at least
 seconds.
The USB HOST mode is cancelled, and "USB
HOST" disappears at the bottom right of the
screen.