Iv-5. Adding Optional Floppy Disk Drive - Canon A-200 series Service Manual

IV-5. Adding Optional Floppy Disk Drive
1. Remove the signal cable and power cable from the "Drive-A" FDD. Disconnect the ground
wire from the body of the FDD by removing the screw.
Signal cable
Figure 4·18
2. A power supply cable for an additional FDD is already prepared on the mounting bracket
of the FDD. Remove it from the bracket by removing the nylon binder.
Nylon binder
Figure 4·19
3. Disconnect the signal cables with connector from the main P.C.S. To disconnect, rotate the
two hooks outwards.
Figure 4·20
4. Remove the FDD with bracket by referring to the paragraph "Floppy Disk Drive
Removal'~
5. Remove the hook of the clam per for the additional signal cables through the hole of the bracket.
In this case apply force to the both sides of the hook and push out the clamper.
Then remove the cables away from the clamper.
Figure 4·21
34