Canon A-200 series Service Manual page 22

5. The right side of the power unit is secured to the chassis with two tabs. Move the power unit
to the left until these tabs become free from the chassis.
t
Tabs
Figure 3-6
6. Disconnect the cables from the main PC. B. in the same manner as the power switch cable.
Push this tab
Figure 3-7
111-1-3. Main p.e.B.
1. Remove the top cover.
2. Remove the power unit.
3. If any optional board such as display adapter or RAM board is inserted into the optional slots,
remove that board.
4. Remove cables from the speaker, keyboard connector, RESET switch, floppy disk drives and
the cooling fan.
Screw Cooling Fan Connector
FDD
Signal
Connector
Keyboard
Connector
RESET Switch
Connector
Speaker
Connector
Figure 3-8
19