Canon A-200 series Service Manual page 131

• SAVE
All errors occurred during a series of Diagnostic program have been recorded into the RAM
of the computer as data. That data will be written onto the head 0, track 04 and sector 1 of drive
A by selecting this command. Therefore, if the write protect notch on Diagnostic Program disk
is covered with a tab, be sure to remove it before executing this command. You can also save
the error data onto other disk which has been formatted by executing the FORMAT command
provided in the DOS.
• PRINT out LOG list
An error data currently stored on the RAM will be printed out to a printer. If the printer is not
connected, following message will appear after a few seconds:
Printer is not connected. Press any key.
When any key is pressed, the error data currently stored in the RAM is displayed on the screen
When listing on the screen is finished, pressing any key allows the program to return to the main
menu.
• CLEAR LOG list
This command clears all error data stored on the RAM and on the disk currently in use.
• RETURN to main menu
Select this command to return to Main menu.
4-COPY
The information stored into Diagnostic Program disk cannot be copied onto another one with
the DISKCOPY command provided in the DOS, because this Diagnostic Program is not con ­
trolled by the DOS. Use this COPY command in making a back-up copy.
Following message will appear on the screen:
Insert DIAGNOSTIC PROGRAM disk in drive A.
Press [ENTER] key to start loading.
Press [ESC] key to exit.
Insert Diagnostic Program disk into the drive A and press ENTER key. When the information
stored on the disk is transferred onto the internal RAM, a message:
Loading completed
Insert target disk in drive A.
Press [ENTER] key to start copying.
Press [ESC] key to exit.
will appear.
Remove Diagnostic Program disk from the drive A and insert a formatted disk instead, and then
press ENTER key.
When the copy is completed a message:
Copy completed !
Press [ENTER] key to return to main menu.
will appear.
128