Specifications - aoyue INT 738 Instruction Manual

SPECIFICATIONS
MAIN STATION
Power Input :
Station Dimensions:
Weight:
SOLDERING IRON
Power Consumption:
Temperature Range:
Heating Element:
Output Voltage:
HOT AIR GUN
Power Consumption:
Temperature Range:
Heating Element
Pump/Motor Type:
Air Capacity:
6
available in 110V / 220V
188(w) x 126(h) x 250(d) mm
6.3 Kg
45W
200°C ­ 480°C
Ceramic Heater
24V
550W
100°C ­ 480°C
Metal Heating Core
Diaphragm Pump
23 l /min (max)
CARE and MAINTENANCE
Solder the other RED wire of heating element with YELLOW wire on
●
PCB.
Solder BLUE wire of heating element with BLUE wire on PCB.
●
Solder WHITE wire of heating element to with BLACK wire on PCB
●
The 5 pin Solder Iron socket can be tested to detect faults in the
hand piece:
Before plugging in the hand piece conduct the following test:
Pins 4 & 2
Pins 4 & 1
Pins 5 & 1
Pins 5 & 2
If any of the above mentioned combination registers a short review the
steps in replacing the heating element to ensure proper connections.
Warning: Ensure none of the above mentioned conditions are
present before plugging in the hand piece. Failure to do so can
damage the internal circuitry of the unit.
Test the resistances of the following configurations:
Pins 1 & 2
Pins 4 & 5
Pin 3 & solder tip
If resistance test conforms to the above tables then the soldering iron
hand piece is deemed working and can be plugged in to the Soldering
Iron receptacle for usage, if problems after installation of new heating
element occurs review the previous steps to double check connections.
Note: resistance value of sensor(Pins4&5) may vary according to ambient
temperature
∞
∞
∞
∞
19 to 23 Ω
1.2 to 3Ω
Below 2 Ω
19