Advertisement
SPECIFICATION
SPECIFICATION
MAIN STATION
Voltage Input :
Station Dimensions:
Weight:
Power Consumption:
Temperature Range:
Heating Element
Output voltage:
FUNCTIONS and FEATURES
•
Microprocessor-controlled ESD safe Soldering station.
•
Ceramic heater and removable tip design.
•
Compatible with Lead free applications.
•
High power heating element for fast heat recovery.
•
Large temperature control knob for easy adjustment.
•
Auto sleep and wake up function.
•
Programmable sleep timer.
CONTROL PANEL GUIDE
1
Set and Actual
Temperature Display
2
Temperature
control knob
3
Main power
switch
AOYUE
SOLDERING STATION
6
available in 110V / 220V
110(w) x98 (h) x 155 (d) mm
1.5Kg
75W
200°C - 480°C
Ceramic heater
24V
4
Calibrate hole
5
Solder iron
®
connector
3210
Int
OPERATING GUIDELINES
Aoyue 936 规格
Aoyue 936 规格
REMINDERS:
1. Make sure the equipment is placed on a flat stable surface and
all the heat-generating components placed on their respective
holders or stands.
2. Ensure all function switches are OFF prior plugging to wall
aoutlet.
IMPORTANT:
Please refer to the CONTROL PANEL GUIDE page
for buttons and display panel directory.
A. INITIAL PROCEDURES
1. Insert the power cord into the receptacle at the back of the station.
2. Plug the power cord into a grounded wall socket. The station is
protected against electrostatic discharge and must be grounded for
full efficiency.
3. Be sure the power switch is OFF before connecting or disconnecting
the soldering iron cord. Failure to do so may result in damage to
the circuit board.
4. Install solder wire to the solder iron holder.
5. Attach the soldering iron to the 5-pin output at the bottom right
area of the station.
6. Place soldering iron to the soldering iron stand as shown in the fig-
ure below.
7. Dampen the sponge with water and squeeze dry before using. The
tips maybe damaged when used with dry sponge.
8. The unit is now ready for use.
7
Advertisement
