Vacation Mode; Auxiliary Output - Automatic Technology SecuraLift Trio Installation Instructions Manual

Coding Transmitters
Step 17.3 - Setting the Transmitter to Operate

Vacation Mode

The opener can be programmed into a "Vacation Mode"
where the opener will not respond to any transmitter
except one pre-programmed unit.
a. Press CODE SET button three times. The CODE SET
LED will illuminate and the courtesy light will fl ash
slowly (once every two seconds) to indicate Vacation
learning mode is active. (Fig. 32)
b. Choose a transmitter button not already coded into
the receiver. Press this button and the CODE SET
LED will begin to fl ash.
c. Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go
out, and the courtesy light will also switch off. This
indicates the code has been stored (Fig. 32).
d. To activate Vacation Mode, close the garage door
and press the coded button transmitter for 5 seconds.
The CODE SET LED will illuminate to indicate that
the opener is in Vacation Mode.
e. To exit Vacation Mode press the transmitter button
momentarily until the CODE SET LED turns off.
Step 17.4 - Setting the Transmitter to Operate
the Auxiliary Output
It is possible to operate other devices (e.g. alarm systems)
using one of the spare buttons of a multi-channel
transmitter coded into the Auxiliary Output feature.
a. Press CODE SET button four times. The CODE SET
LED will illuminate and the courtesy light will fl ash
quickly (twice per second) to indicate that learning
mode for the Auxiliary Output is active (Fig. 33).
b. Choose a transmitter button not already coded into
the receiver. Press this button and the CODE SET
LED will begin to fl ash.
c. Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go
out, and the courtesy light will also switch off. This
indicates the code has been stored (Fig. 33).
SecuraLift ® Trio Overhead Garage Door Opener
Owner Installation Instructions
Press CODE SET
button three times
fi g 32
Select one of the
four buttons (not yet
programmed) you wish
to use to control the
Vacation Mode
Press CODE SET
button four times
fi g 33
Select one of the
four buttons (not yet
programmed) you wish
to use to control the
Auxiliary out put
21