"Delete SMPL," "Copy SMPL," "Move SMPL," "Rename
SMPL," "SMPL To Stereo," "Delete MS," "Copy MS,"
"Move MS," "Rename MS," "MS To Stereo/MS To
Mono," "Conv. To Prog," "Keyboard Disp." (1.1–3f)
SMPL 7.1: Insert Effect
Here you can make insert effect settings for use in Sampling
When you set "BUS" (1.1–3a) to IFX, the external input
sound from the rear panel AUDIO INPUT 1 and 2 jacks will
be sent to IFX (insert effect). By selecting insert effect and
making settings in this page, you can apply the insert effect
to the signal entering through the external input, and sam-
ple the result.
For details on insert effect, refer to p.155 "7. Effect Guide."
In Sampling mode, master effects 1 and 2 and the mas-
ter EQ cannot be used.
Insertion effect settings in Sampling mode are not
backed up when the power is turned off. If you wish to
keep the insertion effect settings, you can use "Copy
Insert Effect" (7.1–1a).
For example, you can copy the insertion effect settings
of Sampling mode to a program or combination in
order save them. When you write the program or com-
bination, the settings will be saved in internal memory.
In Sampling mode, you can use "Copy Insert Effect"
(7.1–1a) to copy these effect settings from the program
or combination back into Sampling mode and use
Here you can select insert effects, switch them on/off, make
chain settings, and specify the pan of the sound after pass-
ing through the insert effect.
These parameters are the same as in Program mode.
gram mode "7.1–2: Setup"
"Copy Insert Effect" (PROG 7.1–1c), "Select by Category"
Sets the effect parameters for the IFX effect that you selected
in the Setup page ( p.164–).
Effect Dmod (dynamic modulation) is controlled by the
global MIDI channel speciﬁed in "MIDI Channel"