Mod Seq-A (Modulation Sequencer) - Korg R3 Owner's Manual

Knob [1]
LastStep
Specifies the length of the sequence in steps
(i.e., the maximum number of steps).
Figure 26-1: SeqType Forward
Forward (Last Step=16)
Step Step Step Step
01 02 03 14
Figure 26-2: SeqType Reverse
Reverse (Last Step=16)
Step Step Step Step
16 15 14 03
Figure 26-3: SeqType Alt1, Alt2
Alt1 (Last Step=16)
Step Step Step Step
01 02 15 16
Step Step Step
01 02 15
Alt2 (Last Step=16)
Step Step Step Step
01 02 15 16
Step Step Step Step
01 02 15 16
46
26. MOD SEQ-A
These are the parameters for the Modulation Sequencers. Modulation sequencers apply time-varying change to the sound parameters in a way
similar to the analog sequencers of the past. One modulation sequencer is provided for each timbre.
Knob [2]
[01...16] SeqType (Sequence Type)
[Forward...One Shot]
Specifies the sequence type (the direction
in which the sequence will play).
Forward: Play from the first step (Step01).
(☞Figure 26-1)
Reverse: Play from the last step (the step
number specified by "Last Step") in reverse
Step Step
(☞Figure 26-2).
15 16
Alt1: Alternately play in Forward and Re-
verse directions. Alt 1 immediately
changes direction at the end points, so the
first step and last steps are played only
Step Step
02 01 once per loop (☞Figure 26-3).
Alt2: Alternately play in Forward and Re-
verse directions. Alt 2 plays the first step
and the last step on both the way up and
on the way down, so these steps will be
played twice per loop (☞Figure 26-3).
One Shot: The sequence will play for only
one cycle, and will maintain the value of
the last step.
(Modulation Sequencer)
Knob [3]
KeySync
Specifies how the sequence will be reset
when note-on occurs (i.e., when a key is
played).
Off: The sequence will not be reset when
note-on occurs.
Timbre: The sequence will be reset when
the first note-on occurs for a timbre from a
condition of all keys being released. In the
case of a program for which different re-
gions of the keyboard play different tim-
bres (i.e., a split program), the reset will
occur for the timbre that was played by the
note-on.
Voice: The sequence will be individually
reset by each new note-on that occurs.
Knob [4]
[Off, Timbre, Voice] Resolutn (Resolution)
Specifies the playback speed of the se-
quence relative to the tempo (MIDI clock)
specified by the [TEMPO] knob. The se-
quence will advance by one step for each
note value you specify here, relative to the
tempo. For example if you set this to 1/4,
the sequence will advance one step for each
quarter note.
[1/48...1/1]