Download Print this page

Korg R3 Owner's Manual: Data Dump

Synthesizer / vocoder.
Hide thumbs

Advertisement

Data dump

6-1. MIDI DATA DUMP
Data dump
"Data dump" is a function that transmits
program or global data in the form of MIDI
exclusive data, so that it can be saved on a
connected MIDI data filer or computer.
This can also be used to transmit data to
another R3 unit.
Do not touch the knobs or buttons of
the R3 while data is being transmitted
or received. Also, never turn the power
off during this operation.
Some USB-MIDI interface devices may
not be able to transmit/receive the
R3's MIDI exclusive messages.
Transmission procedure
Connect the R3's MIDI OUT connector
1
to the MIDI IN connector of a device that
is able to receive a MIDI data dump, and
set both devices to the same MIDI chan-
nel.
2
Hold down the [SHIFT] button and
press the PROGRAM SELECT [6] but-
ton.
The [6] button will blink. The main dis-
play will show the type of data dump
that will be transmitted.
3
Use the [PAGE] dial to select the type
of data dump that will be transmitted.
1 Prog:
Data for the currently selected program
will be transmitted (1. Voice – 39. Lvl/
Pan page parameters, front panel but-
ton and knob settings.)
AllProg:
Data for all programs will be transmitted.
Global:
Global data will be transmitted (40. Glo-
bal-A – 46. Pedal/Sw page parameters,
foot pedal calibration setting, and
formant motion data.)
AllData:
All programs and global data will be
transmitted.
4
Press the blinking [6] button.
The data dump will be executed, and
then the R3 will return to the Play mode.
For more about the contents of pro-
gram data and global data, refer to the
explanations of what is saved in the
sections "Saving a program" and
"Saving Global and MIDI settings" in
"Saving (Writing)" (☞p.74).
For the size of the dumped data and
the time required for each, refer to the
table.
Reception procedure
Use the following procedure when you
want to load previously-saved data from
a connected MIDI data filer or computer
back into the R3, or to receive data from
another R3 unit.
Connect the R3's MIDI IN connector to
1
the MIDI OUT connector of the device
that will transmit the MIDI dump data.
Set the MIDI channel of the transmitting
2
device to match the R3's MIDI channel.
If you previously transmitted data to an
external MIDI device and want to re-
ceive it into the R3, be sure to set the
R3's MIDI channel to the same channel
setting as when the data was originally
transmitted.
3
Set the 43. MIDIFilt page "SystemEx" to
Enable, turn the Shift function "PROTECT"
to off.
The size of the dumped data and the time required for each:
Data to dump
Data size (Bytes)
Time required
1 Prog
452
Less than one second
AllProg
57,856
approximately 3 minutes 15seconds
Global
192,144
approximately 2 minutes 10 seconds
AllData
250,000
approximately 5 minutes 30 seconds
4
Transmit the data from the MIDI data
filer or other device. For the transmis-
sion procedure, refer to the manual of
the device you are using.
77

Advertisement

   Also See for Korg R3

   Related Manuals for Korg R3

Comments to this Manuals

Symbols: 0
Latest comments: