Korg R3 Owner's Manual: Other Shift Key Functions

Synthesizer / vocoder.
Hide thumbs

Other SHIFT key functions

DEMO
Listening to the demo performance
• Hold down the [SHIFT] button and
press the ARPEGGIATOR [ON/OFF]
switch.
The demo will begin playing. While the
demo is playing, you can stop it by
pressing the [EXIT] switch.
Refer to p.11 for details on how to se-
lect songs.
CALIBRATION
Calibrating the foot pedal
1
Connect a foot pedal (☞p.8). Begin this
operation with the pedal set all the way
down.
2
Hold down the [SHIFT] button and
press the ARPEGGIATOR [LATCH]
switch.
The [LATCH] switch will blink.
The main display will show the calibra-
tion setting screen.
3
Advance the foot pedal all the way up, and
then return it to the fully down position.
4
Make sure that the lower line of the
main display shows "********".
5
To execute the calibration, press the
[LATCH] switch.
The calibration settings will be loaded,
and you'll return to Play mode. To save
the settings, write the Global data
(☞p.74 "Saving GLOBAL and MIDI set-
tings").
If you decide to cancel the calibration
operation, press the [EXIT] button.
TIMBRE1 SOLO, TIMBRE2 SOLO
Soloing a timbre
For a program that uses two timbres, this
operation lets you listen to just one of the
timbres. While editing, you can use this
when you want to hear a single timbre by
itself.
1
Hold down the [SHIFT] button and
press the TIMBRE SELECT [TIMBRE
1] or [TIMBRE 2] button. Only the tim-
bre whose button you press will be
heard.
2
Hold down the [SHIFT] button and
press the TIMBRE SELECT button
([TIMBRE 1] or [TIMBRE 2]) of the tim-
bre that you were soloing.
The solo setting will be defeated.
If you execute this while editing, the
timbre being edited will change.
AUDIO IN THRU
Audio In Thru
This operation causes the audio signal from
the input jacks to be sent directly to the
OUTPUT [L/MONO] and [R] jacks.
• Hold down the [SHIFT] button and
press the [VOCODER] button.
When this function is on, the audio sig-
nal from the [AUDIO INPUT 1] (or
[MIC]) and [AUDIO INPUT 2] jacks will
be passed through and sent from the
OUTPUT [L/MONO] and [R] jacks.
This will turn on/off each time you
press the button.
The 41. Global-B page "Thru Src" pa-
rameter specifies the input jack(s) to
which the Thru function will apply.
79

Advertising

   Also See for Korg R3

   Related Manuals for Korg R3

Comments to this Manuals

Symbols: 0
Latest comments: