Product Description; Basic Features; Advantages Of Use - 2N SingleTalk User Manual

1.1 Product Description

Basic Features







Advantages of use














New features


The SingleTalk (ST) is intended primarily for lifts – especially in buildings,
where there is just one lift and no internal communication between the lift car
and the machine room/shaft bottom/lift car roof is needed (2N
designed for more complex applications).
The ST is a Speakerphone in principle. This means that, built-in behind the lift
panel (wall surface), the ST microphone and loudspeaker are used for bi-
-directional voice communication.
The ST can be connected directly to a PSTN line, being supplied from this line.
Thus, it requires no battery and no maintenance. It can be connected to
any local PBX line or a GSM gateway too (refer to the Associated products).
The ST cannot be misused to someone else's debit because it can dial the
pre-programmed numbers only.
On the top of it, the ST can be provided with various extending modules as
needed either on purchase, or any time later.
Basic messages even without the voice recording module
Messages of a variable length of 0 to 30 seconds – with the voice recording
module only
Checking Call once in 3 days
Digitally adjustable acoustic properties (remote setting)
Function indication – two LEDs compliant with applicable lift regulations
Phone-based programming and checking
Hang-up and busy line detection
Automatic repeated dialing of multiple numbers
Protection against unintentional or unneeded initiation (CANCEL)
Call control from the dispatching center
No need of power supply
Easy installation onto any panel
Approved for connection to the PSTN
Amplifier module
Lift blocking module
Product Description 1.1
®
LiftNet is
6