Loading Tabbed Sheets In Tray 1, 2, Or 3 - Konica Minolta Network Printer User Manual

HOME
Maintenance & Supplies
Loading Paper (continued)

Loading Tabbed Sheets in Tray 1, 2, or 3

Load offset tabbed sheets so that the tab extensions are on the left at the rear (not front) of
the tray. The tab extension width should be 0.5" (12.5 mm) or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the
Key Operator mode; otherwise mishandled paper may occur.
The top sheet is designated face down as the first tab of the finished set. Subsequent
offset tab sheets follow in sequence.
Rear
Example: 3 Tabbed sheets loaded in position for one finished set.
Front
1st TAB
2nd TAB
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Rear
Front
1st TAB
2nd TAB
Section 3
Management
Printed
side
3rd TAB
1st TAB
Section 3
Section 3
Management
Section 3
Management
Section 1
Management
Introduction
2nd TAB
3rd TAB
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
ONE FINISHED SET
Section 1
Section 1
Introduction Introduction
3rd TAB
THREE FINISHED SETS
Maintenance & Supplies 8-7