Konica Minolta Network Printer User Manual page 91

Konica network printer user's manual

Table of Contents

HOME

Output Modes

Manual Finishing (continued)

1 Place a set of paper to be ﬁnished into the lower

tray of the cover sheet feeder, as described below

for each mode, then align the guide plate. The

indicator light of Start/Stop button will turn green.

• 1 oblique staple / 2 parallel staples: FACE UP

• Punch: FACE UP

• Stapling & Folding: FACE UP for the outside of

the ﬁnished set

• Three-Folding: FACE UP for the outside of the

folded set

NOTE: Refer to the speciﬁcations on previous page for available

paper size and capacity in each mode.

2 Press Staple Mode Selection button and/or Punch button to select the desired mode.

NOTE: Punch mode is compatible with 1 oblique staple, 2 parallel staples, or Stapling & Folding mode.

3 Press Start/Stop button.

Finished sheets will be delivered to the appropriate tray according to the selected mode.

NOTE: If you want to stop the Manual Finishing operation, press the Start/Stop button again. The ﬁnisher will

cease operating. When using Stapling & Folding mode, the unﬁnished set will be left in the stacker unit

inside the ﬁnisher.

CAUTION

When the Booklet tray capacity is exceeded, the ﬁnisher will cease operating. To avoid this, select the

appropriate print quantity from the speciﬁcations on p. 6-8.

CAUTION:

When the selected print quantity exceeds the Finisher's maximum capacity, remove the printed sheets

while paper is exiting to avoid paper mishandling.

You may also ask your service representative to set the printer to stop printing when the established

capacity is exceeded.

Guide plate

Lower

tray

Output Modes 6-15

Table of Contents