Reset To Factory Defaults; Conclusion - Yeastar Technology NeoGate TG100 Installation Manual

NeoGate TG Series Installation Guide
VoIP trunking, and Mobile to IP or IP to Mobile routes. Please refer to Administrator's Guide for details.

4.5 Reset to Factory Defaults

If you forget the new IP address or the password of admin, or in other cases that you would like to restore
the factory defaults, please reset the device following the below instructions:
Please press the "RESET" button located in the back panel with a paper clip or a pencil tip. You can see the
RUN indicator stops flicker and turns solid. When the RUN indicator turns off, the button could be released
and system begins to reset. During the process, please do not power off until the RUN indicator become
normal which means the reset process is completed.
Note: After resetting, all the configurations made by the admin would be erased.

5. Conclusion

This Installation Guide only explains the installation and basic settings of NeoGate TG Series. For more
functionality and advanced settings of NeoGate TG Series, please refer to the relative documents as below:
"NeoGate TG Series Datasheet"
"NeoGate TG Series Administrator's Guide"
[The End]
http://www.yeastar.com 14/14