Table of Contents
Advertisement
12.3.2
LCD TEST
LCD TEST
Last Update
XXXX/XX/XX
12.3.3
KEYPAD TEST
KEYPAD TEST
0123456789ABCDEF
12.3.4
READER TEST
READER TEST
Scanning ...
Reader 1
XXXXXXXX
Reader No.
Card No.
12.3.5
COMMUNICATION TEST
COMM TEST
TX data = 0
COMM fail
COMM test pass !!
Press any key ...
☞. To test the performance of LCD, press <ENT> key.
As the test proceeds, several characters will move
quickly from right to left. If character of each field on
the LCD is not, its LCD has a problem.
After completing LCD test, it displays updated day.
. Please press
<ENT> key to start the keypad test.
☞
When operating normally, pressing the keys on the
keypad will display the corresponding letter on the LCD.
Note: The letters on the LCD, A, B, C, D, E and F
are referred to <F1>, <F2>, <F3>, <F4>, <ESC>
and <ENT>key, respectively.
☞. To test the performance of the reader, press <ENT> key.
If RF card make the reader read, it displays card and
reader number of which card is read.
☞. To test the performance of input ports, press <ENT> key.
(Before this communication test, connect the RS232
RX, TX wires to each other.)
If there is a problem with the communication perform-
ance, check connections and try again.
As the test proceeds, the characters being transmitted
and received can be seen.
Finally, the LCD displays communication test pass
message.
26
Advertisement
Table of Contents
