Hp Z440 Workstations - Lsi 9217-4I4E Raid Controller Guidelines - HP Z440 Workstation Series Maintenance And Service Manual

HP Z440 Workstations — LSI 9217-4i4e RAID controller guidelines
See HP Z440 Workstation system board components on page 5
connectors.
NOTE: Hard drives attached to RC J8 are designated by the 9217-4i4e BIOS to be boot devices. If the hard
drive connected to RC J8 is a member of a RAID array, the RAID array is the boot device.
System board
connector
RC – Port 0
RC – Port 1
RC – Port 2
RC – Port 3
SATA 0
SATA 1
sSATA 0
sSATA 1
sSATA 2
sSATA 3
eSATA = external SATA (2 ports per cable assembly)
If eSATA is installed, the ODD is attached to sSATA 3.
If 4 SATA HDDs are installed on sSATA and eSATA is installed, there will be no ODD.
HDD = hard drive
ODD = optical drive
NOTE: Only the most common configurations are shown here.
Drive installation scenarios
1 2
SAS HDD1 SAS HDD1–B
SAS HDD2 SAS HDD2–D
SAS HDD3 SAS HDD3–D
SAS HDD4 SAS HDD4–D
ODD 1 ODD 1
ODD 2 ODD 2
— —
— —
eSATA (top) SATA (top)
SATA (bottom) SATA (bottom)
to determine the location of system board
3
SAS HDD1–B
SAS HDD2–D
SAS HDD3–D
SAS HDD4–D
ODD 1
ODD 2
—
—
SATA (top)
SATA (bottom)
Component replacement guidelines 61