Hp Z640 Workstations - Lsi 9217-4I4E Raid Controller Guidelines - HP Z440 Workstation Series Maintenance And Service Manual

HP Z640 Workstations — LSI 9217-4i4e RAID controller guidelines
See HP Z640 Workstation system board components on page
connectors.
NOTE: Hard drives attached to RC J8 are designated by the 9217-4i4e BIOS to be boot devices. If the hard
drive connected to RC J8 is a member of a RAID array, the RAID array is the boot device.
System board connector
RC – Port 0
RC – Port 1
RC – Port 2
RC – Port 3
SATA 0
SATA 1
sSATA 0
sSATA 1
sSATA 02
sSATA 3
eSATA = external SATA (2 ports per cable assembly)
HDD = hard drive
ODD = optical drive
NOTE: If there are fewer than three hard drives in the configuration, the cables from HDD bays 1 and 2 are pre-
plugged to the RAID card adapter ports.
NOTE: Only the most common configurations are shown here.
Drive installation scenarios
1
SAS HDD 1 SAS HDD 1-B
SAS HDD 2 SATA HDD 2-D
SAS HDD 3 SATA HDD 3-D
SAS HDD 4 SATA HDD 4-D
ODD 1
ODD 2
—
—
eSATA (top) eSATA (top)
eSATA (bottom) eSATA (bottom)
11to determine the location of system board
2 3
SATA HDD 1-B
SAS HDD 2-D
SAS HDD 3-D
SAS HDD 4-D
ODD 1 ODD 1
ODD 2 ODD 2
— —
— —
eSATA (top)
eSATA (bottom)
Component replacement guidelines 63